英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字,中文词皆可:

bilge    
n. 船底,船底的污水,污垢
vt. 穿洞,使膨胀
vi. 膨胀,船底漏水

船底,船底的污水,污垢穿洞,使膨胀膨胀,船底漏水

bilge
n 1: water accumulated in the bilge of a ship [synonym: {bilge},
{bilge water}]
2: where the sides of the vessel curve in to form the bottom
v 1: cause to leak; "the collision bilged the vessel"
2: take in water at the bilge; "the tanker bilged" [synonym:
{bilge}, {take in water}]

Bilge \Bilge\ (b[i^]lj), v. i. [imp. & p. p. {Bilged}
(b[i^]ljd); p. pr. & vb. n. {Bilging}.]
1. (Naut.) To suffer a fracture in the bilge; to spring a
leak by a fracture in the bilge.
[1913 Webster]

2. To bulge.
[1913 Webster]


Bilge \Bilge\, v. t.
1. (Naut.) To fracture the bilge of, or stave in the bottom
of (a ship or other vessel).
[1913 Webster]

2. To cause to bulge.
[1913 Webster]


Bilge \Bilge\, n. [A different orthography of bulge, of same
origin as belly. Cf. {Belly}, {Bulge}.]
1. The protuberant part of a cask, which is usually in the
middle.
[1913 Webster]

2. (Naut.) That part of a ship's hull or bottom which is
broadest and most nearly flat, and on which she would rest
if aground.
[1913 Webster]

3. Bilge water.
[1913 Webster]

{Bilge free} (Naut.), stowed in such a way that the bilge is
clear of everything; -- said of a cask.

{Bilge pump}, a pump to draw the bilge water from the gold of
a ship.

{Bilge water} (Naut.), water which collects in the bilge or
bottom of a ship or other vessel. It is often allowed to
remain till it becomes very offensive.

{Bilge ways}, the timbers which support the cradle of a ship
upon the ways, and which slide upon the launching ways in
launching the vessel.
[1913 Webster]

110 Moby Thesaurus words for "bilge":
balderdash, baloney, bilgewater, blah, blah-blah, blain, bleb,
blister, blob, bop, bosh, boss, bow, bubble, bulb, bulge, bull,
bulla, bullshit, bump, bunch, bunk, bunkum, burl, bushwa, button,
cahot, carrion, chine, clump, condyle, convex, crap, dishwater,
ditchwater, dowel, ear, flange, flap, flapdoodle, gall, garbage,
gas, gnarl, guff, gup, handle, hill, hogwash, hokum, hooey,
hot air, hump, hunch, jog, joggle, knob, knot, knur, knurl, lip,
loop, lump, malarkey, mole, moonshine, mountain, nevus, nub,
nubbin, nubble, offal, offscourings, papilloma, peg, piffle,
poppycock, refuse, rib, ridge, riffraff, ring, rot, rubbish, scat,
scum, scurf, sewage, sewerage, shit, shoulder, slop, slops, slough,
spine, stud, style, swill, tab, tommyrot, trash, tripe, tubercle,
tubercule, verruca, vesicle, wale, wart, welt, wind


请选择你想看的字典辞典:
单词字典翻译
bilge查看 bilge 在百度字典中的解释百度英翻中〔查看〕
bilge查看 bilge 在Google字典中的解释Google英翻中〔查看〕
bilge查看 bilge 在Yahoo字典中的解释Yahoo英翻中〔查看〕





安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • Why not just bilge keels instead of a centerboard?
    Bilge Keels-If you can come up with the perfect shape, that perfect shape is likely to work for a very narrow set of conditions You can't trim bilge keels for varying conditions, loads, etc as you can a dagger board, centerboard, bilge boards or lee boards Off the wind, when the centerboard is up, the gains are measurable versus bilge keels
  • Adding Bilge keels to a Hartley Plywood Deep V Hulled Cabin Cruiser
    Re: Adding Bilge keels to a Hartley Plywood Deep V Hulled Cabin Cruiser A simple set of stilts will allow you to stand upright on the sand mud -- a lot easier to put together than adding keels (which, as WHYankee rightfully says, won't turn your power boat into a sailboat)
  • Bilge Stringers - The WoodenBoat Forum
    I'm thinking of installing bilge stringers in my Diablo in the mid section running for and aft I plan on fastening from the bottom up using silly bronze or stainless screws and finishing washers with plenty of goop of course I want to do this to minimize the flex in the bottom in rough water I used this method above the water line when I built the boat Does anyone see any problems with
  • Concrete in the bilge ? - The WoodenBoat Forum
    Now getting back to concrete in the bilge - these itchen ferry designs carring some internal ballast with cemented bilges and keeping a wide beam and some lead ballast keel - turned out to be good cruising designs as Lyle Hess and the Pardys advocate
  • Bilge pump hose fitting through hull - The WoodenBoat Forum
    All my bilge pump hoses (6)just go through the hull (actually the deck, one goes out the side of the cabin!) Oversized hole, build an epoxy filet No fitting Even my engine exhaust has no fitting, just the hose epoxied to the hull Last edited by wizbang 13; 05-03-2016, 06:25 AM
  • how restrictive is ribbed bilge pump hose? - The WoodenBoat Forum
    Re: how restrictive is ribbed bilge pump hose? I've heard numbers ranging from 10- to 30-percent more restriction with corrugated hose versus smooth bore I use smooth bore hose--whatever the difference, I know my flow rate is maxed As to using a larger diameter hose, I would think that would decrease the pressure, effectively reducing the amount of "head" (vertical lift) the pump is capable
  • Removing old flaking paint from bilge - The WoodenBoat Forum
    Re: Removing old flaking paint from bilge You should go looking for (or make) a scraper that will fit into the tight places It can get tedius, like doiing a dental cleaning Chemical strippers will work, but are very messy and clean up is a bugger (It would have to be washed down and pumped out ) Fortunately, nobody looks at the bilge, so a perfect finish isn't essential Just get the loose
  • sealing the bilge - The WoodenBoat Forum
    sealing the bilge 10-25-2005, 12:39 AM Hello, I've just purchased a wood boat and have finished scraping bleaching the bilge What type of sealer should I use? This is a liveaboard so odor after the sealer has dried is a consideration Thanks!
  • Filling bilges - Yes or No? - The WoodenBoat Forum
    The cement brought the bilge up level to the top of the wood keel (as shown below) Water seeping in around the cement has caused some of the frames to deteriorate and I'm replacing them, no problem there The question is about filling in the pockets again
  • Paint recommendations for a trailered, epoxy-coated plywood dinghy . . .
    As for bilge paint - is this even necessary if I'm epoxy coating the inside of the hull? What purpose would it serve in a boat with no engine that's already coated with 2 or more coats of regular epoxy (not the penetrating stuff)?





中文字典-英文字典  2005-2009